Application Fluid (makes vinyl installations faster and easier)
- Fast shipping
- In stock, ready to ship
- Inventory on the way
Application Fluid for Vinyl Wraps Decals Stickers 4oz Sprayer
Vinyl Application Solution
Application Fluid shocked installers by allowing them more control over their applications than ever before. Now what took hours could be accomplished in minutes. Using Application fluid can often allow a large graphic to be installed with one person where two people were required to perform the same installation dry. It also cleans the substrate without leaving residues ensuring a contaminant-free installation. It then helps to “float” the vinyl film until it is properly positioned. Application Fluid’s best feature is that it effectively breaks the surface tension of the adhesive on the film allowing it to flow and bond to the substrate more effectively than even a dry application. It is now possible to achieve a full bond in as little as ninety seconds. Your customers and your reputation will benefit from higher-quality applications. Your bottom line will benefit from faster applications and fewer failures as well.
Detailed Use Instructions
STEP 1. Clean surface thoroughly with Application Fluid and a kitchen paper towel. Do Not Use Other Cleaners Or Solvents.
STEP 2. Spray the surface again with Application Fluid, peel the backing off the decal, and place on the wet surface.
STEP 3. Position decal. Use a squeegee to remove fluid, using a good deal of pressure and working from the center out to the edges in all directions.
STEP 4. Wait 2-3 minutes. Saturate paper cover tape, if any, with Application Fluid, then remove the paper tape. Wipe the surface with a paper towel.